TRAINING HYSIS FIELD PROCESS ENGINEERING DESIGN FOR OIL GAS

Training Desain Teknik Proses Hysys Lapangan Untuk Gas Minyak

Training Component And Component Behavior

OBJECTIVES
1. Understand the basic concept of oil , gas and water handling processes and facilities, and how to operate this technology in field application.
2. Diagnostic of oil and gas reservoir performance under actual drive mechanism and future performance with current handling processes.
3. Analyze the production potential of reservoir under with actual handling system processes and to plan the better development processes according to reservoir capacity.
4. Understand the fundamentals of microscopic and macroscopic aspects and phenomena of oil, gas and water handling processes.

TRAINING OUTLINES

Introduction
1. The role and responsibility of each member of discipline
2. The different type of project that proses engineering are involved with
3. The complexities of a project
4. A basic understanding of the deliverables each type of project.
5. A basic understanding of the schedule for the different type of project

Process Simulator
1. What is process simulator
1. What are they
2. How they are used
3. How to determine the suitable one
2. Process simulator needs
1. Component and component behavior
2. Process flowsheet or description
3. Operating condition or design specification
4. Calculate steady state process of heat and mass flow
5. Model the surface facilities and gas plant
6. Design or process evaluation
3. Step to modular simulation(Hysis)
1. Specify component and thermodynamic model
2. Define process configuration
3. Specify stream or unit operation connectivity
4. Operation parameters are ready
5. Run simulation
6. Result Checking
7. Check the simulation result is in line with the real design practice
8. Verify the result

Process Simulation Unit Operation
1. Select Hysis calculation block to represent process equipment
2. Understanding of unit operation in Hysis
3. Understanding single stage separation in Hysis

Process Simulation – Set & Adjust
1. Describe the characteristic of feed forward controller
2. Describe the characteristic of feedback controller
3. Understand how to use SET as feed forward controller
4. Understand how to ADJUST as feedback controller

Process Simulation – Crude Stabilizer
1. Understand stream mixing and splitting block
2. Understand pressure change block
3. Select suitable heat transfer block
4. Model a simple crude stabilizer

Recycle Stream
1. Select suitable tear stream
2. Installing recycle loop stream

INSTRUKTUR

Sigit Budi, ST., MT and team

PARTICIPANTS

Senior operators, Junior operators, Junior production engineers and supervisors, Well service engineers and supervisors, Materials, Logistics and warehouse personnel, Work over and Well services engineers and supervisors

METODE

Lecturing, presentasi, diskusi interaktif, sharing, studi kasus